Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you use ads
so at the left hand of the control
above the "display properties "button
0----0e+00000 (blue)
360-----xe+00xxx (red)
change the x ,and "enter"
the Contrast ratio is changed
you'll get it
both
care about magnitude
i think it's impedance discontinuess
i change the transmission that connect to the pins to
taper , it works ,but a little
the
poblem remains....
Re: HFSS port problem
hi ,CUONGTRAN
thank you for your help
my design is a lange coupler
i want to simulate it in the HFSS
for network problem , i can't upload my file
i want to add wave port to the coupler , how can it be added in the right way ?
thank you in advance
for a lange circuit
how to add wave port ?
first , how i did it
assign->wave port->p1->number of modes 2->set newline at the microstrip edge
p1(port1)have two modes ,what does mode mean ? two stimulations ? or
propagation modes ?
i get a bad result
i change the wave port to lump...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.