Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi
i work with elc for characterization cell. my config file is this
SETUP = "/home/test/cds/test/setup.ss"
PROCESS = "typical"
SUBCKT = "/home/test/cds/test/inv.scs"
MODEL = "/home/test/cds/test/model-file.scs"and my setup file is this
Process typical {
voltage = 1.8 ;
temp =...
hi all
i was created .lef file with abstract generator but when SOC read this file, i get two error:
SOCLF-121: you need to have cut layer after 'METAL1'
SOCLF-3 : Error found when processing LEF file './abstact.lef'
anyone could tell me why?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.