Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
sir plz help me..........my rs-232 circuit is ok...my jz863 transceiver is working properly but problem is that my data is not displaying on hyper terminal...baud rate is also ok...what will i do??.....
How i can use hyper-terminal to view this data that i have sent ? and when i use virtual terminal in proteus simulation then i see my previous data continously.....
actually...how will i send counter program to computer...and how will i display on hyper terminal......???????
---------- Post added at 22:31 ---------- Previous post was at 22:30 ----------
Another thing is that i have a problem in hardware too...
ok sir let me check & tell you...
---------- Post added at 12:27 ---------- Previous post was at 12:11 ----------
sir problem is that i want to sent bit of data just like 'wireless', so then what will i do and other thing is that and i want to display my counter on terminal.exe just like...
i have already connected max232 circuit and i hav a problem in programming and i want to show on hyper terminal....if u want then i will give my coding..and give my ur email ID.....actually my project is that to count steps and to take pulses per min then both data show on PC...
hey....where is the attached file....:-(
---------- Post added at 18:06 ---------- Previous post was at 17:55 ----------
thanks...i got the file but how would i covert it to 60 sec and another thing is that i want ot show my result on lcd........
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.