Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
antenna equations
hi
you can use the following perfect refrence papers.
1. "I/P impedance of annular ring microstrip antenna using circuit theory approach" IEEE Trans on antenna and propagation Vol. AP-33, No.4, PP.369-374, April 1985.
2. "A broad -Band annular ring Microstrip Antenna" LEEE...
annular ring patch antenna
hi
you can use the following perfect refrence papers.
1. "I/P impedance of annular ring microstrip antenna using circuit theory approach" IEEE Trans on antenna and propagation Vol. AP-33, No.4, PP.369-374, April 1985.
2. "A broad -Band annular ring Microstrip...
Re: Microwave Office
Thank you very much for All
How are you? I hope all of them fine.
Thank you very much BigBoss for reply
Ok, but I set the top boundary of enclosure is approximate open 377 Ohm, that mean the enclosure is approximately opened roof. For more explanation the setting up of...
Microwave Office
Hi Friends
I'm trying to simulate Microstrip Patch Atenna by using Microwave Office software on dielectric substrate of second layer of 2 layers enclosure. 1st layer is air with er=1. It is suppose that the height of the 1st air layer is not active on the final results of port...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
