Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
philips pm5132
Hi!
I urgently need manual / service manual / schematics for function generator
Philips PM5132.
Thank you very much!! :D
Best regards,
HALABAT.
Hi,
i strongly recommend you to build up a Microchip Picdem.net clone.
You can use the software provided with TCP-Lean provided in the
upper post.
I've build up several of them, working fine :-))
With the best regards,
Halabat.
Re: labview+controller
Hi, it's just an easy job!
Look at the Functions Menu:
All functions -> Instrument I/O -> Serial
There are the following vis:
VISA Configure
VISA Write
VISA Read
VISA Close
Just use them for programming your application.
If you want you can use Instrument I/O...
measuring amplifiers with pc soundcard
Hi!!!
Accuracy is always a problem by measurements via soundcard, because there is no reference!
In TrueRTA you can make a calibration with an AC voltmeter for the voltage level, for the frequnecy response there is a selftest utility with a sweep test for...
ni imaq webcam
HI mobile-it,
as i know the motion/picture function are working with national instruments equipment only! Not with standard usb webcam. :-((
Halabat :)
Re: GPIB card
Hi,
I'm using Ines IEEE488 with Labview without problems. First you have to install the systemdriver, then you have to install Agilent I/O Libraries.
Then you can access the GPIB Card in the Ni MAX Setup program.
If you need the driver kit pm me.
Good luck, Halabat.
webcam labview
Hi,
i was using a Logitech Quickcam with the following driver in Labview 6.1
h**p://www.info-labview.org/the-archives/vi/lv4/lv_vfw.zip
Easy to use and powerfull :-))
Halabat.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.