Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: 8 layer stack up
Thank you all,
i have made two stacks, one with polaris software and one with Altium integrated impedance calculator. I`ll write to my pcb vendor to check what will be his suggestion.
Hi all, i need help with stack up 8 layer board with controlled impedance 50 ohm (+-10%) on all layers for 0.125mm tracks. Can you help me please ?
board thickness 1.6mm.
The stack up is :
------signal
------GND
------signal
------VCC
------GND (signal)
------ signal
------VCC
------signal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.