Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I have an question about the ESD.
The picture I've attached is an ESD protection circuit for digital output.
I've used this pad but I wanna change the circled nMOS size of output inverter at this time because I need to drive more current than before.
The problem I've encountered is...
I use spectre for all first design and modification. And then I use Hspice for final post simulation. I use the extracted netlist after the layout was finished.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.