Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I'm editing a pcb document in altium that has been designed by someone else. the problem is that some component are stick together and i can't move or rotate just one of them alone. what should i do?
thanks
hi everybody
:)
I'm working on mc3356 FSK receiver . I have a problem with quadrature detector section. what i have understood : this section must make a voltage (on pin 13 or 12 in Fig.1) that is proportional to the difference between input signal frequency (on pin 7) and frequency...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.