Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks for reply:
in fact I'm looking for a schematic using a PIC18 DIP package like 18F4620 and a ENC28J60 (also DIP).
I already downloaded the above link, but I found nothing inside looking like my project.
Thank you
hello:
I'm looking to build an ethernet to serial interface, using PIC µC(like 18F4620 or others ), does anyone have a schematic(with firmware) for that?
Thank you
Hello:
I'm trying to simulate an ethernet interface between a PIC16F887 and a server written with C#, I referred to MIKROC software and schematics. I still at early stage trying just to send a string to the server. when I launch the simulation I got an error saying:
"Cannot open network...
hello:
for building UPS, let's say 12/220V for example, there is two topologies: either a 12-0-12/220V with two transistors, or a 12/220V with a full-bridge of 4 transistors.
what's the advantages and inconvenients of each topology?
Thanks
You can command an opto-triac like MOC3020/3040 by the microcontroller (or similar), then the opto will drive a bigger triac (like BT138) connected to the load. This way, you maintain isolation. Schematics are provided in the datasheet of the MOC3020/40, so have a look.
Regards
Added after 1...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.