Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i will check the web, thank you jiripolivka,.
I am studying about IPD capacitor, and my first step is searching for the High K material, I'm using BSTZ ceramic as my material.
Can you explain to me how to measure with the microstrip line?
As I know microstrip lines can measure broaden...
Re: using microstrip line to measure the dielectric constant
Hi Phytech,
I dont know if you will see this or no,
Can you tell me where did you get the formula for measuring the dielectric constant with the microstrip line?
Thank you
using capacitor just can be used in low frequency measurement , anyone can teach me how to measure dielectric in high frequency? maybe microstrip line?
Hey guys,
I know that adding a dielectric in a two plate can add the charge in the plate, so it can add the capacitance.
But I have a problem, When we place the dielectric in the E field, there is a dipole moment which produce internal E ( E polarization ) that opposed the E field, so the E...
hi,
as I know the quality factor definition is energy stored/energy dissipated.
i found two formula to calculate it and got the same result
1. -Im(y11)/Re(y11)
2. Im(1/y11)/Re(1/y11)
Is there any relation between these two formulas?
and some other using impedance z to calculate it, is it just...
hello guys, can you help me?
like the title i'm designing the antenna with HFSS
but I didnt get any good result in S11
It's like that there isn't any signal going to the port
can you guys help me look at it
Thank you:-)
Hello,
Is there anyone know what is the difference of perfect E, perfect H, and finite conductivity? And when we must use it? or say which is more accurate ?
THanks
i have tried using wave port.. i analyzed it, but it stopped.. it said that port refinement, process hf3d error. port 1 is assigned into internal face. Only allowed with lumped port....
actually, i still don't understand about antenna ... all i do is learning how to use the software and copy the sample drawing..
THanks mkonca...i will try using wave port... =D
zorro, i dont really understand what you mean above...
ANyway... do you have any reference (book, ebooks or website)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.