Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This is quite a difficult task for the pcb fabricator and it is very rear and very expensive it this could be done.
______________________
NO SIGNATURE LINKS ALLOWED
Hello,
There different approach in connecting the analog and digital ground in different applications.
For example for power supply (AC to DC) Switch mode, the termination for both analog and digital should be in the negative terminal of the bulk capacitor for the primary side and for the...
Hello,
I'm a hardware design engineer with specialization on Power supply both switched mode and linear application, high wattage or low wattage. I think we can help you in your designs.
email: pcb1001(at)gmail(dot)com
Krgrds,
Kris
Hello,
I have a mechanical friend with a wide experience in plastic casing also for portable media player.
Please do send your dxf of you pcb at pcb1001(at)gmail(dot)com so we can build a 3d drawing for you..
krgrds,
kris
rf dc block
Hello guys,
I a circuit used in gps application. Its an LNA connected to a RF switch. My problem is how to solved the correct capacitor to couple between the LNA and RF switch. Please see attached picture for you reference.
Thanks in advance...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.