Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
internal usb connector pinouts
The whole trick is the power supply. If you hooked up the data lines right, you sould be fine. What I did is used a LM317 (you can find a datasheet for these)
The LM317 has 3 pins: Adj. , Vout , Vin
C1 - 1uF Tant., C2 - 3.3uf Tant. (I used 3.3uF, 1, 2.2...
what pin number do i put in for wlan
Ok, I know this is a little late (2 yrs) but I have one of these and decided to make it work. The trick is that the unit requires a 3.3v power supply isolated from the 5v usb vcc.
USB pin 1 VCC isolated
USB pin 2 Data (-) - yellow wire
USB pin 3 Data (+) -...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
