Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello again, i have been trying to get this implemented in CST but with not much luck.How do i incorporate the capacitor in order to get the tag to resonate at 13.56?
your help would be much appreciated
Thank you FvM for the quick reply.Yes,it does make sense, but in CST environment do I just insert an capacitor (equivalent as per chip spec)? Or there is other method of accounting for this?
Kind Regards
hello everyone
I am trying to simulate in CST a RFID tag antenna which should resonate at 13.56 MHz(NFC antenna)
After designing it (at this stage I picked an antenna from a IEEE journal ) I have run the simulation (Time domain Solver) but the antenna impedance value does not match with the one...
hello everyone
quite new in this field so please have some patience with me :-)
i have to design a dual band dipole antenna resonating at 13.5 MHz and 866 MHz with port impedance 13-13.5 (real) and 120-130(imaginary) parts with dimensions not greater than 40 by 40 mm2
i have designed some...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.