Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Forget that cc2500 unit, you can get a TI ez430 (USB Interface) and use the free IAR software or a simple unit like: **broken link removed** (USB Interface) and use the digi XCTU software.
ATMEL AVR, FREESCALE, & MICROCHIP
MUST BE DESIGN PARTNER of ATMEL, FREESCALE, or MICROCHIP
MUST HAVE WEBSITE THAT EXPLAINS YOUR DESIGN SERVICES
USA OR INTERNATIONAL
MANY INQUIRIES FOR DESIGNERS
SEE:
**broken link removed**
See top of page for details!
Inductor value needs calculated. Needs to be at least .75A higher than the rated
value, and the switching frequency will also be important. Just can't randomly
pick the components. Capactors are selected based on ripple current capability
and low esr. I suggest you go to Linear Tech and download...
1. You need a Laser 1064nm wavelength.
2. Power requirements about 200vdc@400Amps
energy is pulsed at about 1Hz to 2 Hz rate.
3. In addition you need a simmer voltage about 1KV to simmer
the laser before firing.
4. Detectors to measure the energy being delivered.
5. A fiber optic delivery...
Contradictions
Are not many.
1. Euro EMC standards can be met. EMC is highest in high current loop,
the switch, catch-diode, and LC filter. Keep this loop between these components as short as possible. Inductor must be shielded. You wont have any compliance problems.
2. Line surge's....use a...
Can play with this
clock doubling circuit, to operate at approx 500kHz, using CMOS logic.
+-------+
| hc86 |
+-----------| |
clkin ----+ | +--- clkout = 2*clkin
+-N-R-+-N---+ |...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.