Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I've got a sensor that counts the number of LED pulses and transmit the value every 60 seconds. The value will be around 30 to 60 decimal.
The receiver will receive the data via 433Mhz wireless and output the value received via RS232 to the PC.
I'll check the pulses and post results tonight.
I'll have a look at the modules.
For the project I'm busy with I only need to transmit one byte every minute so i could transmit the byte 3 times to make sure the correct data is being received.
Thanks for the code - I'll have a look into it and see if I can get it going.
Just don't seem to be having luck with these 433Mhz modules.
If I can't get this going can anyone recommend a fool proof way of doing wireless comms between 2 microcontrollers. Are there better/easier wireless...
I've purchased a 433Mhz receiver and transmitter from spakfun and have used one of the links on their page to build a receiver and transmitter using the AtMega8
I can see the transmitter working and on the data pin of the receiver I can see the same waveforms being received that are being...
I have just build the P16PRO40 and am using WinICProg to program my PIC.
I tried posting this message on the winicprog site but there seems to be a problem with the registration process.
I have tried toggling the button in the hardware setting and I get the following:
vpp on: MCLR = 12.85V...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
