Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Klaus,
thank you for reply,
I might be wrong,
but soft start is seen on the plot as increasing peak current limit during first couple of cycles.
So it looks like to me as soft start is too "short".
"An inductor saturation rating minimum of 760 mA is recommended. "
Yes it is true, but...
Hello,
I am designing buck converter using MCP16301
Vin 14V
Vout 5V
Iout 125mA
https://ww1.microchip.com/downloads/en/devicedoc/20005004d.pdf
I have chosen inductor for it:
SRN3015TA-220M
22uH, saturation current 550mA
https://www.bourns.com/docs/Product-Datasheets/SRN3015TA.pdf
I have a...
In my opinion it looks like output under voltage protection tripping in.
Try to mess with voltage divider going to feedback pin (I assume it is primary side regulation).
Hello,
I need to some help to find more information about circuit connected to ADJ pin (D2, R23, D1, R22, C54).
Has this circuit a name (so I could google that)?
What function it has?
Is it some kind of start delay or transient filter circuit?
Thanks,
Greg
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.