Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can use an AD595 from analog, just place an ADC after it.
It's in the factory laser-trimmed and the output is nearly lineair, so you don't have to calculate too much.
I did it a few years ago, it works fine.
Regards,
Goof
8051 can bus
Hi friends,
I try to make a little network with canbus, 1 master 1 slave.
This because I want to figure out what is possible with CAN.
I want to buiold it with an 89s8252 and an external CAN-controller (82527). It will be programmed in the best C51 compiler.
Maybe there is...
8051 fat32
Hello,
is there someone who has a project in KEIL connecting a HARDDRIVE to an 8051. I'm not a pro and to programm on my own is an too hard job.
Hope someone can help me.
Send it to goofers at lycos dot nl.
Thanx
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.