Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
8051 ports
Hi,
I am trying to communicate to the 8051 via the UART and then trying to control the device, but the port values that I connect the device (sensor) is all wrong. The port value is -1, 32518 etc.. which is neither a high nor a low in the program which I can check for. Any advices...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
