Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
My school's ADS was sponsored by Keysight years ago and our support has expired. But we are still allowed to use the software. Thanks. I can still use other EM simulators such as Sonnet for that, but I would prefer to use momentum together with ADS circuit simulator.
Hi, when I run simulation from ads schematic window using parameterized layout setup, everything is ok and I did not get any error. However when I run it from command line using
hpeesofsim netlist.log
I get the following errors:
RESPONSE FROM COMMAND PROMPT
Characterizing the circuit...
Good day, recently I've done sumulation using ADS command line to automate circuit simulator. My command line looks like this:
[status,cmdout] = dos(['hpeesofsim C:\Users\USM-POSTGRADE\Documents\MATLAB\ADS\',netListFileName]);
which I did using MATLAB. However, I did not find any document...
Hi, Thanks for your response. As I know Differential Transmitter in ADS can only output something like [-0.3 0.3] V. I want it to ouput [1.05 1.35] V to be input to the coupled line. However, if i set vhigh as 1.35V and vlow as 1.05V, then I get v+ as [0.525 0.675] V and V- as [-0.525 -0.675]...
Can Tx_diff and Rx_diff in ADS be used to model a LVDS Transmission Line? And if yes, then is a 100 ohm resistor enough to be used as termination, should I add other components like capacitor? Normally, do the designer of the transmission line has the freedom to decide how the line is being...
The eye_height() function need the input arguement in the form of y = eye_height(Vout_time, Delay, BitRate, SamplePoint, WindowPct). Below is the format of my equation editor:
y = vt_tran(Vout, 0); //Vout is my output voltage and 0 represents the GND
EH = eye_height(y, 0 ps, 1 GHz, SamplePoint...
Good day, I need a way to automate eye diagram measurement because I need the data for neural network training. I want to integrate neural network training in MATLAB with data collection process. Can anyone help me? Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
