Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
i am new using micro c. i am using pic16f877a microcontroller but i do not know how to configure its ADC. can anyone help me please.
i want to use channels AN0,AN1,AN2,AN3 for my inputs...please send me a code.
that is why sir arun i am opening this problem because i am new to this micro c just a couple of days. i appreciate if you give me a sample code sir thank u so much
hi everyone,
i am using MICRO C for my PIC16f877a micro controller but i have a problem encountered regarding the adc configuration and and making conditions in comparing constants.
i have 3 inputs which in need to be read in adc.....
1st input ...the adc read it. then it compares to a...
hi everyone,
i am using MICRO C for my PIC16f877a micro controller but i have a problem encountered regarding the adc configuration and and making conditions in comparing constants.
i have 3 inputs which in need to be read in adc.....
1st input ...the adc read it. then it compares to a...
hi please help me configure the adc using micro c for PIC16F877A microcontroller. please.....
i want to use 3 inputs for PORT A ....RA0/AN1 (PIN 2), RA1/AN1(PIN 3) , RA2/AN2/Vref-/CVref(PIN 4)
there is Vref at PIN 5 which is RA3/AN3/Vref+....
can some one lend me a code for this...
Sir is this code is a micro c code?
---------- Post added at 00:56 ---------- Previous post was at 00:53 ----------
hi please help me configure the adc of PIC16F877A microcontroller. please.....I AM USING MICRO C
i want to use PORT A as 3 inputs......RA0/AN1 (PIN 2), RA1/AN1(PIN 3) ...
hi please help me configure the adc of PIC16F877A microcontroller. please.....
i want to use PORT A as 3 inputs......RA0/AN1 (PIN 2), RA1/AN1(PIN 3) , RA2/AN2/Vref-/CVref(PIN 4)
there is Vref at PIN 5 which is RA3/AN3/Vref+....
can some one lend me a code for this please.
Hi ,
Can anyone help me please.
I am using PIC16f877a microcontroller, i want to control a relay. i am using a current sensor. the current sensor will convert current to voltage. .the voltage from the sensor serves as an input to PIC16f877a . there is a condition. if the reading is greater...
HI
can anyone help me?
I am new using micro c pro. i am using pic16f877a, how to configure ADC? please can anyone lend me a code for configuration?
i have a current sensor which will convert current to a certain voltage. and this voltage is serves as an input to pic16f877a.
i want to use...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.