Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: CAREER DECESION
Hi Deepak,
Welcome to the forum. Recently i have come across some statistics from EDN. It states, Very less skilled people available in Board design. This demand very high pay in this domain. Board design expected to grow very fastly. So, if you want to go for Board...
Re: Ground plane rules
Hi,
try to check the following points :
1. Check any of the traces crossing the split planes under the routing layer.
If yes, re-route and avoid the crossing.
2. Change the traces from top or bottom to internal layers.
3. pour the copper under the component and provide...
Re: Ground plane or not?
Hi,
1.Try to isolate the Analog and digital area, when you are going to pour the copper.
2. Also don't route any trace across the pour area. If you desperately wanted then, provide 3*Width of the line gap between the pour and your traces.
I hope this suggestion would...
Hi,
Pls go through the PDF file located :
www.ecd.com/downloads/emfg/ DataShts/Barriers&Thermocouples_HR.pdf
I hope this link will be helpful to identify the insulation medium, that should be selected to avoid the corrosion.
GK
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.