Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The TC65 works as the master of I2C bus so the uC should act as slave. You have to command the TC65 throw the UART to open the I2C hardware using the AT^SSPI command. You also have to put pull-up resistor from TC65_SCL to TC65_VDD and from TC65_SDA to TC65_VDD. I put 10k resistor.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
