Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi folks.
This is my first attempt at a four layer board and first board involving high speed signalling (USB 3.0).
The spec sheet for my USB 3.0 hub component (TSUB8020B) recommends controlled impedance of 90Ω +/- 10%. I've plugged these figures into Altium and it's recommending track widths...
Sorry to reanimate this thread but I ran into a similar issue and this thread was one of the first results when searching.
I solved this by looking at my Altium rules. There is a rule under Routing -> Routing Layers and this was set to only allow routing on the component layer. I didn't create...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.