Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
After choosing your desired object or surfaces Try complex mag E instead of vector E. If you don't pick surfaces only you will get a cloud plot. HFSS will autoscale to the maximum E field found. Remember that quantities sjhown are peak and not RMS
Create a rectangle or surface or identify an object face where you want your resistor.
From top menu HFSS>boundaries>assign>impedance enter the ohms/square
of your resistor and the reactance(usually 0 for thick/thin film)
Pay attention to the substrate and leads going to your resistor. Getting...
right click on the HFSS field overlay to select "edit sources"
the the power delivered to the antenna is
solved magnitude(1 W default) x scaling factor x (1-|S11|^2).
Change the scaling factor to make the delivered power 1 watt.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
