Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by gertoth

  1. G

    Seeking VHDL Good & cheap FPGA designer.

    PM to me.
  2. G

    IC design/verification job opportunities in Canada?

    Atmos, MoSys in Kanata
  3. G

    salaries for embedded engineer

    what is the medium monthly salary in belgium Senior specialist earns 500 euro/mounth in Ukraine.
  4. G

    Looking for a VLSI design job

    Re: vlsi design job Has anyone got radiofrequency vlsi design job? Pls, PM to me.
  5. G

    Cell library or Design kit for Cadence

    Try it. https://www.cadence.ncsu.edu/CDK.html
  6. G

    Looking for a DSP Core in VHDL or Verilog

    On site CMOSexod.com is this. **broken link removed** 12bit DSP core and peripherals. Suitable for performing real-time signal processing, such as equalizer on stereo audio inputs. Viewlogic / (3 Lattice isp30256, 4 Lattice isp1016). **broken link removed** But shematic is only making...
  7. G

    Looking for a DSP Core in VHDL or Verilog

    Open Project "OpenDSP" "A 16-bit fixed-point DSP Processor for FPGA" **broken link removed**
  8. G

    Designing a homemade PC oscilloscope circuit

    soundcard pc scope I know very cheap and simple device. There could only some resistors and soft on PC. h#ttp://h#ome.w#xs.nl/~m.f.ha#jer
  9. G

    where to migrate form microchip ?

    I used Fujitsu MB90F497. 16bit CPU ,Low cost(~7$), 1CAN, 2UART, FLASH 125KB, timers, C compilator, debugger. ATmel Mega more expensive, and less possibility.
  10. G

    Full design of a 70 MHz Digital Oscilloscope - RS232

    oscilloscope rs232 mhz There is very simple and cheap oscilloscope. h#ttp://ho#me.w#xs.nl/~m.f.ha#jer
  11. G

    PCI Prototyping Board

    pci prototyping The easy way is implemintation you PCI gate with PLX-9050. You could not write special driver, using standart one. I think that, it's not easy task, writing driver.
  12. G

    need Mifare card detailed information

    I have source A^VR for Mifare card.
See more

Part and Inventory Search

Back
Top