Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
So with optimal filter.
In table " _RLCF.PDF (220.4 KB)" I can match all- R, C, L, Frequency.
Need only Adobe Acrobat (not only reader) with moving color line, across wanted parametres and get your's choise set.
If you want so match at 50 Hz, yoir's L and C is close optimal for R load = 27...
Input terminals are internally diode-clamped to the power-supply rails. Input signals that can swing more than 0.3V beyond the supply rails should be current limited to 10mA or less.
Only R2 = 5 kOhm is enouth.
See Figure 18. "Input Current Protection" of datasheet.
Cable will be same resistance, (designed with) as transmit line to it on PSB, and matched with output connector. What is your's connectors? In connector datasheet may be any about matched cables.
At input the resistanse are very large, and potencial are saved at capacitanse of gate no discharged. Virtual input sourse signal had very large resistanse too.
There needed additional resistor, connected to gate and ground about 1 Mega Ohm.
Hi gentlemans! More actual question is where is table with extremal parametres: GBW, power supply, Settling Time and so on. Any like Ginnes Book?
Note: Sometimes great GBW or BW no enough. Settling Time is very important parametr, it determine yoir ability produse large amplitudes at HFl...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
