Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi so is it possible to interface webcamera wth pic 18f4550 or almel 328p microcontrollers...i jusy want to captures images and then store in a flash memory like usb storage device.thanks in advance
hai thanks
can u please give litle more directions and procedues about image processing and face recognition in labview. i find it difficult to understand from the site.
thanks
I have a small sugestion.have u checked lithium polymer battery ..it gives aroung 12volt and high current >15 amps..the cost increases as the amps requirments increases but the weight remains very small...the weight to power ratio is approx 0...it will help u.
I just did few reaserch work and found out that the quadcopter mainly needs only accelerometer.getting the orientation is not actually needed to get the quad balance in air..accelerometwr will do the job.
I have a sample code for arduino to balance the quad.i used mma7361 accelerometer. Pls...
hi i dont thinh u need schmitt trigger for attaining that output..u can use 2 comparators as usend in 555 ic. the upper comparator triggers in 4 volts and lower comparator triggers in 3.5 volt. u can use 2 op-amps as comparators.and resistor network to divide voltage as per ur need.
hope it helps.
hi
i am completely new to labview. but i am interested to know if video processing is possible using labview and also if face recognition is also possible or not?
thanks in advance.
for all ur purpose u might need to have configurations
>4gb ram
>320gb hdd
i5 or greater processor
512 graphics for high end apps(not sure)
3 or 4 usb ports
u might also need serial and parallel ports if doing microcontroller programming etc.. so u can use usb to serial or usb to parallel...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.