Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yes u r rite that hex..just show the values...but if u map these values on acssi table...then this the strange symbol...not the desire data what iam sending from microcontroller.....
I dont under stand what do you mean by this.....change Tx and Rx at one side of the circuit...!!!
plz help me to solve this problem....terminal not receive the"AT" ,showing some thing else....all baud rates are set to 9600...i attach code and pic, may help to identify the problem...thx
-------------------------------------------------------------------------
#include <at89x52.h>
void...
Simulate from proteus....the code and snap as u seen before......virtualy conected com1(proteus) and com2(hyper terminal)....iam sending "at" by using sendstring function....so hyper terminal should show on screen "at"...but isnt !..shows some strange symbol....even i tried terminal insted of...
All baud rates are matched,physical baud rate,virtual baud rate and hyper terminal baud rate are set to 9600
---------- Post added at 18:59 ---------- Previous post was at 18:51 ----------
sorry....how to change that "auto detect setting" in hyper terminal...?
---------- Post added at 19:05...
yes...but how to solve that problem...or what is the reasion of that problem....is there any thing wrong with code or simulation process....or some thing else......can u help me !
Iam tired to figure out the problem..hyper terminal shows some strange symbol,try a lot of time......i download virtual serial port driver from https://www.Eltima.com ...i attached code and proteus simulation pic.....plz help me...
I want to cheack AT commands responce but i dont know about proteus so kindly help me that how to connect atmel8052 controller to compim or any other way to cheackk....plz send me the diagram if possible..thanks
I want to cheack AT commands responce but i dont know about proteus so kindly help me that how to connect atmel8052 controller to compim or any other way to cheackk....plz send me the diagram if possible..thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.