Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Interior surface coating of a copper resonant microwave cavity?
Do most people just leave the interior surface with a nominal coating of copper tarnish and it doesn't affect the Q much or does it?
I was just wondering because with a gold plating I think it usually has a nickel plating under...
Yeah, its perpendicular.
- - - Updated - - -
Yeah, I had already designed the brick work and it all worked out to so many pieces that the material and fab cost was really going up. It was then I started wondering if I could use sheets of something and laser cut a lot of gaps towards the...
I'm trying to gather information about what types of magnetic material are most economical for a large flat LC resonator, 18 inches by 18 inches by somewhere between 1 to 3 inches high. I need 18x18 flat sheets of magnetic material on top and bottom that route flux to a center magnetic material...
Later yesterday, after posting my questions, I came across what people are calling a "Lenz lens" which is utilized to concentrate flux. It uses a similar gap but they are usually flat or wire frame and not conduit shaped.
Also later yesterday I heard back from the patent's listed inventor. She...
I came across a patent for a thick wall copper tube with an electrical gap in its side so there won't be current flow. Does this type of design actually work for concentrating flux? Like this: https://patents.google.com/patent/US6720855B2/en
If this flux conduit doesn't work, how do people...
It is for driving ultrasonic piezo elements. The 2 same type transistors are connected in what looks like kind of a push pull configuration driving an output transformer at ultrasonic frequencies. The 2 transistors are the only active devices on the card. The output is also feed back to an...
I know what you mean but I don't see any TO-3 packages at the Diodes Inc website.
I was looking for much higher hfe transistors but wasn't finding much. I'm afraid to use a Darlington because I'm thinking the original transistor wasn't Darlingtion so if I install a Darlingtion I might get...
No problemo, sorry I took it the wrong way.
I think I just need to look for a cheap switching TO-3 NPN transistor , maybe 250V or higher with about 10A capability.
I'm going to try a BUX32B.
What's a good cheap switching low saturation NPN TO-3 transistor that can handle at least 250V 10A and have enough gain to insure oscillations start? Switching frequency about 50KHz.
- - - Updated - - -
Switching frequency about 50KHz.
Does anyone know what is a Harris C9006 800637 TO-3 package used in an oscillator/driver circuit?
The circuit is not working and this part appears to have an internal short but I don't know what it is.
I tried to get support at the Intersil website to find more info but their website hangs up...
Thanks, I've seen 25 ohms used other places but a few places mention even lower and I can't find anything that defines why the cable impedance should be lower.
The class E output MOSFET can drive low impedances but the final output needs to match a 50 ohm antenna cable and antenna, so I'm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.