Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks guys. Good information.
With this information at hand, I will make another few test and ask an external electrical engineer to design me the actual and final pcb, with the power supply, filters etc.
You are the best.:wink:
I will have a look at it. Vishay WSK Serieshttps://www.mouser.es/new/vishay/vishay-dale-current-sensing-resistors/( Kelvin Sensing).
I know, I came with the simplest circuit and left it there. I am not a electrical engineer but I can understand all that you have told me and it has been very...
What about "The low-side resistor adds undesirable extraneous resistance in the ground path"?
Actually, during the test I carried out on the circuit, I have seen in my scope that for a duty cycle of 100msec, the differences between voltage peaks are 330uV at maximun.
I going to sustitute the...
Hi,
I have read this article from maxim:
https://www.maximintegrated.com/en/app-notes/index.mvp/id/746
Apparently using a high-side configuration is better because. "The low-side resistor adds undesirable extraneous resistance in the ground path" and "an accidental connection that bypasses the...
I am working on designing a current source for a LED driver, which can work up to max:16A, as long as the driver stays on less than 500msec. Actually, the leds circutry is a Dome-light which is divided in 4 sectors. The 4 sectors have a common ground and they are trigger in PNP mode(24Vdc)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
