Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
May be you can use LM35 Centigrade or LM34 Fahrenheit temperature sensor and for microcontroller pic12F675, 10 bit built in adc converter.
As an language for pic programming , I recommend basic compiler, easy to use and for this proyect , i think you can get easy to realize.
For basic editor ...
Check this site , may be useful to you :
you can use two ic , one for -B and other for +B
sorry if I don't understand the concept of your question.
Useful tool , good job !!
Can you write a version for standard register setup like this ?
PR2 = 00100000 ;
T2CON = 00000101 ;
CCPR1L = 00010000 ;
CCP1CON = 00011100
Or may be you like share source code , I can code in delphi and make modifications for write new application...
parking proximity alarm circuit
I want to build a automotive alarm.
When the vehicle reversing parking , sense the distance from another car or wall etc etc.
I think in ultrasonic receiver transmitter or infrared distance measurement and microcontroller design.
I have repaired a lot of this equipment in the past.
The schematic of power supply not found in the service manual, only a poor block diagram.
The power supply module figure as TK15.
This procedure can be help you
first of all disconnect the...
I need replace damaged transistor from old TDI Yamaha 1100 motocyrcle.
The part labeled is ETD32 -835B 8N16 TO3 CASE.
Please anyone can give me information or help about replcement part.
First of all thanks for reply my post .
I want to get information about USB-to-Ethernet Interface
Thank you for answer, ADM8513 is the solution that I need .