Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Everyone,
I am trying to simulate simple 1 turn coil to see the magnetic field created at the center of the coil on CST simulation tool. The steps I followed are as below;
- I created a single turn coil which has 10cm diameter in low frequency domain.
- Then I cut very small part of it, and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.