Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yes,if you use a follower drive the load,and the gate voltage is lower then the drain ,the MOSFET is not completely on,than it will hot.So you also can ues a DC-DC source to drive the Gate.These problems are commonly seen in driving H-Bridge(if all are NMOS).
but if you put the load on the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
