Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello,every one
can anyone tell me how to analyze the "lossy integrator",or recommend relative references.
it consist of an operational amplifier and R//C as the feedback load
thank you
10-bit flash adc
I am glad to exchange idea with you too
can we communicate by email?
my email is :lianlianhonghong@163.com
Added after 3 minutes:
I am glad to exchange idea with you too
can we communicate by email?
my email is :lianlianhonghong@163.com
flash adc design
Thank you for your answer.
Can you explain the R and C in the following formaluation more clearly.
"sample or conversion time > RC * n * ln2"
and the following are my question of the above formulation
1.how does the formulation being obtained, can you recommend a paper...
hello,everyone
Iam designing a flash adc now.
To generate the reference voltages, a resistive reference ladder has to be used, and my problem is i don't know how to determin the value of the resistence.
Can anyone tell me how to determin the value of the resistence?
can anyone give me the...
calculate snr matlab
hello,everyone
I have completed a flash ADC, and i want to use the matlab to process the data simulated by hspice, so as to get the INL,DNL,SNR,and so on.
but i don't know how to do it, can anyone give me an example or some methods to do this?
best regarads.
hello everyone
i am now reading some thesis on filter
the dynamatic range is mentioned frequencyly,bue i don't know what is the meaning, can anyone explain it
eg: dynamic range(THD<-40dB) 54dB
thank you
hello everyone
i want to do a vga in uwb system, and in many thesis it should contain a dc offset cancellation cell. In most thesis ,it contain OTA+LPF+(V-I converter) and inserted between the output of the whole VGA and the output of the first VGA cell
it's just a sketch map, and i am not clear...
hello,everyone
i am doing a vga simulation in cadence, but i come up against difficulties:
i want to see the waveform about the gain versus the vctrl(the voltage to control the gain )to certify whether they have exponential relation
but i don't know how to do it
a reference told that i can ust...
Thank you for your reply.
My VGA is full differential architecture , and according to you sample ,I write sentence like this:
Vinp 2 0 dc=1.2v ac sin(0 0.5m 100meg)
Vinn 9 0 dc=1.2v ac sin(0 -0.5m 100meg)
Vctrl 4 0 dc=1.3v
And the outputs are connected to node 5 and 11 respectively
(the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.