Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello guys
Do I need to replace my FBT with an exact model #?
its model is 6174V-5003R
what about 6174V-5003S and 6174V-5003L ??!
what are the differences between these?
what would happen if I replaced using any of these?
Thanks
I asked about raising the gain because that is the only thing I made before 2 or 3 months of the very first failure
I just raised it slightly, perhaps 10% more than the original settings
there is no sign of any visual issues for the picture
for such a great picture I am really surprised that...
Thanks Bryan
I was watching the TV for a weak with a great picture with the first silicon fix and then that new fault happened, the replacement is about 1/4 the price of the whole set, I would still like to fix it but do you think that it is only that FBT?
I dont see any sign of other component...
yes sure the housing is opened and I can see the spark (not arcing) but is kinda visible through the sealing!! there is no ***** or hole that you can see
it is like a relay sound with a spark (on/off)
is that normal? why it is not arcing like last time?
is that a short inside the FBT?
thanks...
I got that set (RT-29FB75VE) in a very good condition with a great picture
it worked fine for about 8 month then the FBT arced out due to a tiny hole discovered int it
I sealed it with silicon sealant and worked fine again for a weak (about 70~80 hours) then the fbt is making a clicking spark...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
