Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
this was a very long time I have not come to this forum and i have one question.
Generaly, i use Ansoft designer to make my RFID antenna, so i would like to try CST Microwave by exporting a dxf design.
I have a little big problem: i don't know how can i place my RF port (My chip...
Hello,
Anymone could say me how can i connect the lumped port and discret port (in a same time) on my RFID UHF antenne using CST microwave?
Thank you so much
hi guys
i have this problem too i make an rfid passive tag in uhf band
my antenna is a replied dipole and i don't make an measurement of impedance caus eil dipole an my merasure is wrong
have u any idfeas pls
regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
