Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I connected the photodiode (current source) as shown:
If i measure the voltage across + and - input of op. amp. i don't get 0V, but the voltage rises proportional to current from current source. How is that possible? Rolling Eyes The op. amp. is TLC2272 and Vcc is 5V. I get 0.35V across at...
light intensity sensor
I am looking for light sensor for measuring the sun light intensity (range from 0 to 1000 W/m2). Any idea what sensor can i use? I found TSL sensors, but the range is not suitable.
I have a stepper mottor driver ic - TMC249, which has to be controlled like this: photo below. I would like to change this to step and dirrection contoll. What logic gates should i use and how should i connect them?
I would like to make a precise distance measuring device (distance from 0 to 1.5m). I was thinking about interferometry. Any plans? What laser should i use?
current regulation (AC)
I would like to limit the current through the transformer at the primary side of the transformer which is connected to 230V AC. How can i do that?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
