Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thx again. I should mention that I had the same problem with the 555 timer put this file is an Op-Amp TL 072 functioning at 3000 to 1000 kilo hertz and I can not see the same wave form that I see on my personal oscilloscope. I should be seeing a sine wave and all I see is a straight line.
Thx...
Hello everyone
I am using Proteus Issis and I can't seem to show the pulsed output of an 555 chip with a simple 2 resistor and 1 cap in a simple astable mode. I can't show the waveform on the oscilloscpe in Issis. Any ideas
Thx in advance
Francisco
Try US Digital
---------- Post added at 21:18 ---------- Previous post was at 21:10 ----------
US Digital has a complete line of optical encoders to mount a pretty much any application.
Thank you both for your quick replies Now it builds until line 27 and then I get error code" Indentifier expected but " found. Also the next errors are ..... Pointer required.....internal error........and invalid expression.
Hello everyone
I am both new to this site and new to Pic programming.Can someone tell me what is wrong with this. It will not build in MikroC and I get the first error at line 10 " Syntax error Expected ")' but found "="
unsigned long value; // store the value of channel0
unsigned char...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
