Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
Here is a list for all free optics, photonics & lasers simulation softwre
If you know other free softwares (opensource, educational versions, ... etc)
mention them in a replay and I will add them to the list
pyofss
**broken link removed**
MPB...
Thanks for all your help
The original problem was how to measure a matching circuit (matches from 25 to 50 ) ?
the answer was to terminate the 25 ohm side with a "matched" 25 ohm impedance to avoid reflections
so I want a termination, either printed or SMT or IC, that has a load impedance of...
Hello
I want to ask for ideas for graduation projects in the field of renewable energy
I want it to include solar cells in someway or the other
Any help would be appreiated
Also books or tutorials or other supporting materials would be a great favor
Thanks in advance
Hello
I want to buy a 25 ohms termination that can be mounted on a printed circuit board (PCB)
or I want an SMA connector with 25 Ohms impedance
Thanks in advance
Best Regards
the loss tangent represents the loss in the dielectric
so if the loss tangent of the dielectric is high, the antenna efficiecny would be low as the losses are high
on the other hand if the loss tangent is low this will enhance the antenna performance in terms of GAIN & efficiency
Hello
I am making a GSM board and I need it as small as possible
What is the smallest possible connector to connect an external antenna
I can buy any antenna with any cable but I must decrease the size of the board the the minimum
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
