Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Don't forget the amount of current a bond wire takes depends on its thickness.
I use 0.0005 / 0.0007 thou bond wires and i wouldn't recommend going above 200-300mA for this thickness of wire.
If current is an issue don't forget you could use gold tape, anyhting from 0.0005 to 0.002 thou can be...
c source temp sensor pdf
I'm not sure if this would help
but for circuit temperature monitoring you could use a ref02 which has a 2mV/Deg C temp coefficent.
wadell brian ~pdf tranmission
i used to use supercompac (i think thats what it was called) run under unix at work,
it was great for transmission line synthesis.
Does anyone know if a windows version existed.
if so does anyone know a link?
microstrip prototype circuit boards
any protyping i do , i use double sided copper laminate protype board, then mount components upside down, and join with small links
add a liberal selection of decoupling, and you can get good results.
bfp420 vco
The best Oscillator i have built was on
20thou alumina, with a 10 GHz puck / cap,
power was coupled in via a 10db coupler into
a mwt amplifer.
Being a DRO it gives extremely good phase noise requirements.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
