Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
toroidpro
I use now PCAIRL program to design coils for RF filters, I search for software for design of toroids with ferite core, something like Toroidpro??
Re: QuickWave 3D error: "Project contains bi-phase elem
Read the manual, biphase are elements that are meshed in 2 steps:
1.Drafting PHASE each component will have his own meshing.
2.fINAL PHASE software will mesh automaticaly a common mesh.
These are elements that each should have a different...
Re: LTCC Tutorials
LTCC at very high frequency:
1. Advantage it is multilayer lot of place to hide your DC lines, some Rf components can be designed in the multi layer, to save place in mmics, main advantage coeficient of expansion similar to GaAs, so you don't need covar, and you can use LTCC...
combline design
Combline filter if wide band then use Wenzel&Horton synthesis ,
case of narrow band use MYJ book (Mathaei) as a begining point, in practice narrow band combline filter are heavily dependent on size versus frequency. For small size low frequency they work nearly as Matheai...
Re: about multiplexer
[There are lots of papers in IEEE-MTT transations, make a search.
You can find good information in MYJ book("microwave Filters,impedance matching networks and coupling structures". Also look for books or papers by following authors: David Rhodes, Ian Hunter, Ralph Levy...
Re: Why this filter has such poor insertion loss characteris
[Sure you can use this connector to Xband, but you have to match connector to 50 ohm microstrip line. Going from 50 ohm coaxial to 50 ohm microstrip might cause at 3ghz bad return loss (-16-14db). You have discontinuity of coaxial pin...
Filpro is a good software for beginning the design of cross coupled filter, also PCFILT and SFILSYN could be used see www.alkeng.com
Filpro is more general, PCFILT /SFILSYN are specific for triplets or quadruplets design.
If you need papers on the subject you will find in the IEEE-MTT...
Hi
PCFILT from ALK Engineering can design a coaxial HP fILTER.
Go AKLENG site and try demo. Most filter companies (K&L, Trilitic, etc ) use this software it is quite cheap and the support friendly.
Re: 2.5d accuracy
I remmember that most of those software companies took part in a benchmarking of EM suites, the test was the vivaldi - most of them claimed victory including EMPIRE .
But as a matter of knowledge there are some classes of EM simulation tools and not all are the same:
1...
EM software in general cannot calculate the influence of roughness on the loss, leading usually to optimistic loss.
To calculate loss they need to apply correction formulas based on experience or measurment. tHAT CAN CHANGE RESULTS BY 0-100% OR MORE.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.