Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
thank you for your fast responce. I put the 50 ohm resistors to increase the damping factor, without taking into consideration the efficiency because I forgot it. I put a snapshot of a simpler circuit and a second snapshot of the output. It seems to work fine. The problem now is how to...
Hello,
I'm trying to drive the gates of two N-mosfet for a class D amp(2N6661). I have Vrail(+)=70V connected to the drain of the high mosfet and Vrail(-)=-70V connected to the source of the low side mosfet(snapshot 1). To drive them fully on I have to apply +-90V to both gates. Is this normal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.