Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello i want to ask,if i design the layout pcb like a picture, if the transistor input that I rounded was sharpened like in the picture what would affect the matching impedance?
is the addition of the resistive component the value free without calculation? and I have tried inserting a series resistive component but the MAG becomes small?
, i would to design the power amplifier with transistor CREE CGH40006S if i want to matching impedance is always not matching ,does it affect the stabilizing circuit? because I just give arbitrary resistive value at the input?
Thanks for your explain, but iam sorry i didnt understand
how to find z source and Z load with tool in ADS ? Iam so confused because when iam calculate with formula and get the value, when iam insert the value to smitchart utility is always not match ? thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.