Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Now am I to doubt, I send the AT commands for SIM RealTerm and 340 works fine, but a code written in C and I can not run the module.
What may be happening?
void putch(unsigned char byte)
{
while(!TXIF)
continue;
TXREG = byte;
}
putch('A');
__delay_ms(40);
putch('T')...
Good afternoon everyone ...
I am programming the PIC16F883 and did what grabik now, but I'm having some problems:
By the time I'll send putrsUSART ("\ r \ n \ 1234567890ABCDEFGHIJKLMNOPRSTVZXYQW");
In RealTerm hours appears: ABCQW in 234QY again, I am not able to send complete.
Below is the...
Problems with netrev.
Good afternoon ...., am using orcad 16.3 and created a schematic in Capture, but when I create the netlist netrev gives error in what follows. What can it be?
Problemas com netrev.
Boa tarde...., estou usando o orcad 16.3 e criei um esquematico no Capture, porém quando...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
