Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would like to run an AC sweep for a very simple circuit (Please see the attached file). Unfortunately the following errors occurred:
L_L2 N04540 0 .10976mH
R_R3 N04968 N02907 10.7849 TC=0,0
C_C6 N04540 N04968 7.6091u TC=0,0
C_C5 0 N02907 .64335u...
Thanks for your wise answer;So what do you suggest for the impedance matching (a practical solution)? Please give me the detailed information about the solution; Thanks again.
Hi friends,
I am new on the forum and hope to learn a lot here. I want to design an audio transformer for an underwater acoustic power amplifier for the purpose of Impedance matching. I want to know how to calculate turns, impedance, watts, etc. Unfortunately there are few literature surveys on...
Hi friends,
I am new on the forum and hope to learn a lot here. I want to generate burst waveform in OrCAD® Capture program version 16.5 (Something like the one shown in the figure below). But unfortunately I do not know how to do that. Now I am seeking your help; any info about the problem...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.