Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanx for the reply
In this case you dont use a H- bridge to do the switching rather a switching circuit output signal is fed to a combination of transistors in parallel to get high current gain. correct?
But I am interested in using a non CT transformer to stepup the output of H bridge. If...
I understand what you are trying to say. But what i meant was the output can be controlled by only one side being fed the PWM signal and the corresponding high or low side transistor on the other side can be just keep On for the half cycle via a square plus.(since the output current would be...
Now I want to know what if you dont use 340 VDC and instead run the H bridge stage with 12 VDC source.
Now to have working voltage of 220VAC, use a 12-220 VAC step up transformer at the output of the H bridge. Will the circuit still work. Guys your feedback would be appreciate.
Added after 5...
Sine Wave inverter.
I agree with samnang39. It seems that you have no concepts or knowledge about basic electronics. I would like to advise you to pick a inverter schematics and see how different components work. you need to learn about transistor working no matter BJT or FET. Only than you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.