Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Previously this was the closest thing I could find commercially I've thought about converting an old stove-top range heating element and putting underneath the heater block, but it was too cumbersome and I wanted to limit the danger excessive heat. Both posts help me immensely in narrowing my...
Basically what I'm looking to do is make a 2"x4"x1" metal brick that gets hot up to about 300-400 degrees Fahrenheit, and plug it into an American wall outlet. It would be nice if I could control the heat with more than an on/off switch or by pulling the plug. As you can probably tell I'm a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.