Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for reading this message. I have now worked out most of the procedure, just one problem: which task should I set up to simulate the antenna together with the switches?
Hi,
I'm trying to simulate an antenna array together with switches in CST, and meet with two problems:
1. I'm not sure about the procedure. My solution is: add the S-parameter document of the switch into touchstone in schematic view, connect the corresponding ports, add a new task 'block'...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.