Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Anyone interested in doing this project kindly let me know. I want to get rid of my t630 and it's data cable reasonably. Email me. You can have my source code and hardware as well
in T630, there is a 'dual function' pin. I'm not sure which one is it already as i have not kept in touch with this topic since 2007.
The dual function pin can:
absorb power:
when charger is connected to T630
supply power
when connected to headset, data cable and other accessories.
So yea...
Attached are my final schematic and hardware connection. Basically i think you need to buy the data cable for T630/610 because their pin outs are too close to each other. I would not recommend you to try soldering jumpers onto them as the pins may be damaged easily due to high heat. The PIC...
I have search them... the only thing relevant to GPS is the AT*EACS command. HOwever that is just set command... i thought the handphone could provide some sort of GPS location or coordinate... Since it was can be used as a car tracker.
hi all, i using a sony ericsson T630. I would like to know if there is any AT commands to turn on/off T630 as well as to locate its location/coordinate. In that way, it can be used as a GPRS kind of a thing to locate a stolen car or vehicle... thanks!
I have written a code for a sms controller. The code works perfectly well in hyper terminal, but when connected with SE T630, it doesn't seem to work at all. I found out that the main reason was the SERIN2 part, if i had that part remove, the code can be run on SE T630. But that only makes my...
pic basic programming
blueroomelectronics, i have only three months to complete it. What is worst, my supervisor is not providing any help to me also... I am totally on my own and besides that i still have three other subjects to study... erm, i understand that you have written many books on...
serin+hyperterminal
anyone know how do i interface the PIC with the hyper terminal using RS 232? what are the syntax for it or where can i get them? thanks... also, how do i tell the PIC to place an "enter/carriage return" key?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
