Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks so far.
Specs are as follows:
Voltage of signal to trigger the switch: 4~5 mV, current is next to nothing
Voltage over the main circuit: 4~5 V. also here current is next to nothing (this is also just a control signal to unlock a door)
The pulse is for 2-3 seconds, but I only need the...
Hi!
I don't know if this is the right place to ask, but I have to give it a shot.
I'll leave out all the booring details;
I have a device that issues a "control signal" - a low voltage pulse - on the press of a button on a remote handset.
What I need it to do is to connect two wires, like a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.